Artikel und Blogs

Wollen Sie frische Lebensmittel im Weltraum? NASA setzt auf LEDs

Mit Hilfe von LED-Beleuchtung hat die NASA herausgefunden, wie man Weltraumnahrung schmackhafter machen kann.

Wie die University of Minnesota und DigiKey in kurzer Zeit Beatmungsgeräte für den Einsatz gegen COVID-19 entwickelten

Wie die University of Minnesota und DigiKey zusammengearbeitet haben, um schnell ein brauchbares massentaugliches Beatmungsgerät für COVID-19-Patienten auf den Markt zu bringen.

Stromversorgung für raue Umgebungen mit den Leistungsmodulen PFH500 von TDK-Lambda Datum der Veröffentlichung: 2020-03-19

Die Leistungsmodule PFH500 von TDK-Lambda erfüllen die Kriterien des Industriedesigns für raue Umgebungen.

Die Grundlagen von IO-Link und seine Nutzung zum Einstieg in das industrielle IoT Datum der Veröffentlichung: 2020-01-15

IO-Link verstehen und anwenden, um intelligente Sensoren und Aktoren in einer IIoT-Anwendung effizient und kostengünstig einzusetzen und mit ihnen zu kommunizieren.

Verstehen der Kompromisse beim Drohnendesign vor der Ausstattung mit zu vielen Sensoren Datum der Veröffentlichung: 2019-11-19

Die Ausstattung von Drohnen mit Sensoren erfordert eine sorgfältige Balance zwischen Leistungsaufnahme, Funktionalität und Kosten. Dieser Artikel enthält einige geeignete Optionen, um dies zu bewerkstelligen.

Künstliche Intelligenz in Energiemanagementsystemen: Wie lautet Plan B? Datum der Veröffentlichung: 2019-10-17

Zur Absicherung eines KI-basierten Stromversorgungssystems stehen Entwicklern u. a. MPPT, die Sensor-Fernüberwachung und ein GaN-Transistor in einem Stromversorgungs-PoL zur Verfügung.

Power Modules and Devices to Support Intermediate Bus Architecture Designs Datum der Veröffentlichung: 2012-05-01

Almost three decades ago, the "brick" DC/DC converter power module was developed, which eventually led to the distributed power architecture (DPA) becoming the de facto standard for point of load (POL) designs.

An Engineers Guide to Power Inverters for Solar Energy Harvesting Datum der Veröffentlichung: 2012-04-04

Home energy systems based on renewable sources, such as solar and wind power, are becoming more popular among consumers and will gain increasing support from governmental bodies.

Flow Sensors Calculating Volumetric Flow and Mass Flow Datum der Veröffentlichung: 2012-03-29

Flow sensors are used to measure flow velocity, volumetric flow rate, or mass flow of a liquid or gas. Mass flow for gases is specified in units of standard liters per minute (slm) or standard cubic centimeters per minute (sccm).

Distributed Power Architecture DPA Choices Using Power Modules Datum der Veröffentlichung: 2012-03-06

What once was a straightforward act of transforming an AC waveform into a DC source to power downstream devices is now greatly affected and driven by the power grid to maximize its available power.

AC/DC Power Module Line Filtering Datum der Veröffentlichung: 2012-01-17

Powerline filters protect expensive circuitry from potentially damaging power surges, as well as protecting the AC line from excessive noise conducted back into it from a noisy power converter.

Challenges and Solutions to Powering DSPs ASICs and FPGAs Using Power Modules Datum der Veröffentlichung: 2012-01-10

Modular, high-density POL (point-of-load) power DC/DC converters have some excellent advantages over other power management architectures.

Conducted and Radiated Emissions Reduction Techniques for Power Modules Datum der Veröffentlichung: 2011-12-27

DC/DC converters are a great high-frequency noise source. Designers must take careful steps to minimize and contain this noise near and around the converter to keep it from affecting other system components or the AC mains.

Optimal Power Management Techniques in Energy Harvesting Designs Datum der Veröffentlichung: 2011-11-30

Battery size constraints in energy harvesting systems necessitate creativity and innovation in order to maximize efficiency of the power source.

LowCost Ambient Light Sensor ALS Solutions Using Analog Output Devices Datum der Veröffentlichung: 2011-11-10

Ambient light sensor (ALS) products are quickly becoming one of the most effective solutions for power management and display quality enhancement in electronic products and systems.

Focus on Power Module Margining and Pre-Bias Startup Features Datum der Veröffentlichung: 2011-10-18

As newer applications and systems tend to have multiple voltages to power DSPs, µCs, FPGAs, and ASICs, modern power supply designs must be able to control how and when these voltages ramp to their final values after the power switch is activated.

Humidity Sensors and Signal Conditioning Choices Datum der Veröffentlichung: 2011-10-13

Relative humidity (RH) is defined as the ratio of the partial pressure of water vapor (in a gaseous mixture of air and water vapor) to the saturated vapor pressure of water at a given temperature.

Proper Use of Thermal Derating Curves for Power Modules Datum der Veröffentlichung: 2011-10-04

Designers using modular power converters for their systems know how critical a thermal derating curve is to the success of their design.

RTDs, PTCs, and NTCs: How to Effectively Decipher This Alphabet Soup of Temperature Sensors Datum der Veröffentlichung: 2011-09-14

Need a temperature sensor for your next application? You'll first need to sort through the three-letter acronyms before arriving at any BOMs.

Environmental Sensor Solutions: Gas Detection Datum der Veröffentlichung: 2011-09-08

A gas detection sensor’s function is to measure the concentration of gases. These devices have different methods to convert the gas detection element’s output to voltage.